MAINTENANCE CLASSES
Precision Cycles is pleased to offer cycle maintenance classes in Hampshire.
The aim of our classes is to give you the skills to maintain your bike and do roadside repairs but more importantly give you the confidence to carry out basic work yourself which will ultimately help you to keep your bike in top condition!
Our new venue for courses at Andwell Brewing Co’s Brewhouse, near Basingstoke has its own parking plus ample space and facilities for us to adhere to COVID guidelines and as usual our classes are always carried out in small groups for more personal learning.
Date and times for our classes are detailed below:
​
Please use the REGISTER INTEREST buttons below to enquire about courses.
- Please note Level 1 courses will be capped at 4 people and Level 2 courses capped at 3. ​
- Please note that participants must be 16 years old or over unless accompanied by an appropriate adult (please notify us of this when requesting a course place, as limitations may apply with regards to COVID restrictions).
LEVEL 1 (BASIC) - £45
This course is aimed at individuals who want to gain more confidence with the mechanical side of their bike. By the end of the 2 hour session, you will be familiar with the components on your bike and be happy to perform a pre-ride inspection as well as the following.
Course Topics:
-
M Check - bicycle safety inspection
-
Cleaning and lubricating
-
Puncture repair and tyre care
-
Roadside fixes
Course location
Upcoming Courses 2020
Nov 13th - 1800 to 2000
Nov 20th - 1800 to 2000
Nov 27th - 1800 to 2000
​
Dec - No Courses
​
​
Andwells Brewery Brewhouse, Hook,
RG27 9PA
LEVEL 2 (DEVELOPMENT) - £95
This course is intended for individuals who have a sound knowledge of the basics and want to get to grips with the larger jobs on a bike. Fault diagnose will be covered in detail, which will then lead nicely into exploring specific areas of the bike in greater depth.
Course Topics:
-
M Check - Fault diagnose
-
Gear setup - From re-cabling through to full gear setup
and fine tune
-
Wheel Hub adjustment & bearing type
-
Headset types and adjustment
-
Bottom Brackets - all varieties discussed along with extraction and
installation
-
Case by case tech topics discussed
Course location
Upcoming Courses 2020
Nov 14th - 1000 to 1600
Nov 21st - 1000 to 1600
Nov 28th - 1000 to 1600
​
Dec - No Courses
​
​
​
Andwells Brewery Brewhouse, Hook,
RG27 9PA
Cancellation Policy:
If you cancel your booking between two and one week prior to the start date, Precision Cycles will charge an administration fee of 25% of the course fee.
Cancellation one week or less prior to the start of the course, or failure to attend, will result in no refund being available.
Delegate substitutions can be made up to three days prior to the start of the course with no charge.
If Precision Cycles need to cancel a course, a place will be booked on the next available course at no further cost to delegates.
Payment of the course fee is required within 7 days of the course date to allow delegates to attend.